I. Round Water tower Working condition :

Water inlet temperature:37°C

Water outlet temperature:32°C

Wet bulb temperature:28°C

Dry bulb tem peranure:31.8°C

Atmospheric pressure:9.94×10000Pa

Material: glass fiber reinforced plastic (GFRP)

II. Environmental choice

1, Should avoid installed in waterproof channel, easy to reflect the walls of volume, must be packed in roof or air circulation place.

2, With two or more cooling tower and, attention shall be paid to minus its spacing.

3, Should not be installed in all outer wall or tight place, and should pay attention to minus its exterior wall spacing.

4, Should avoid to install a soot and dust more places, the top jams film.

5, Should be far away from the kitchen and boiler room wait until a hot place.

III .Installation points

1, The foundation should level can't tilt, cooling tower in vertical lines not plane, or influence than motor cloth.

2, For the above 175 T cooling water pipe should be attuned in bearing.

3, Circulating water in and out of the shuttle, appropriate is used the shock absorber throat connection.

4, Cooling tower, clubs and column wall fan blade gap should be consistent and never allow two side there are a big gap and solve the problems found.

5, Motor and reducer to regularly check to fix, reducer should check the oil a.